Simultaneous removal of cyanobacterial blooms and production of clean water by coupling flocculation with a rotary drum filter

Environmental Science and Pollution Research - A mechanical harvesting technology based on coupling flocculation with a rotary drum filter (RDF, 35-μm) was applied to remove cyanobacterial...     

电解铝企业阳极残渣、阳极残极浸出毒性鉴别及管理建议

对电解铝企业产生的阳极残渣、阳极残极浸出毒性进行了鉴别。鉴别结果表明：电解铝企业产生阳极残渣浸出液中氟化物（不含氟化钙）平均质量浓度为140 mg／L，最高达244 mg／L，且超标试样数达到《危险废物鉴别标准浸出毒性鉴别》中相应规定，鉴别该废物属于危险废物，应按照危险废物进行管理；阳极残极浸出液中氟化物（不含氟化钙）平均质量浓度为74 mg／L，无超标试样数，该废物不属于具有氟化物浸出毒性的固体废物，建议仍按一般固体废物进行管理。     

EGSB出水回流对EGSB—SBR工艺处理果汁废水的影响

采用EGSB—SBR工艺处理实际果汁废水(COD 2 608~6 500 mg/L,p H 5.0~7.0)。在EGSB反应器成功启动及驯化完成的情况下,连续运行49 d。实验结果表明:第25天起,控制EGSB回流比为3.00∶1,EGSB反应器可在无须添加Na HCO3的条件下稳定运行,从而降低了废水处理成本;第25天起,平均进水COD,BOD5,SS分别为5 968,2 130,1 020 mg/L,平均出水COD,BOD5,SS分别降至131,11,50 mg/L,平均COD,BOD5,SS去除率分别为98%,99%,95%;组合工艺对该实际果汁废水具有良好的处理效果。     

Preparation and Characterization of Collagens from the Skin of Northern Snakehead (<Emphasis Type="Italic">Channa argus)</Emphasis>

Channa argus, a type of snakehead fish native to China, is a popular food fish in certain Asian countries but is a known destructive invasive species in the US. In this study, the two collagens, i.e. acid-soluble collagen (ASC) and pepsin-solubilized collagen (PSC), were obtained from C. argus skin. The yield of ASC was 28.0% and that of PSC was 16.8% on the dry bases. The collagens were identified as the collagen of type I by SDS–PAGE patterns. The Tds were approximately 27.0?°C. Similar ultraviolet spectra of both collagens were observed. Fourier Transform infrared spectra indicated PSC structure had a little change due to the loss of terminal domains by pepsin digestion. The results of XRD proved that the two collagens retained their helical structures. The results suggest that the collagens isolated from C. argus can potentially be alternative sources of vertebrate collagens for use in the food and other industries.     

One-Component Spray Polyurethane Foam from Liquefied Pinewood Polyols: Pursuing Eco-Friendly Materials

The use of petroleum-derived products should be avoided regarding the principles of green and sustainable chemistry. The work reported herein, is aimed at the liquefaction of pine shavings for the production of an environmentally-friendly polyol suitable to be used in the formulations of sprayable polyurethane foams. The biopolyols were obtained in high yield and were used to replace those derived from fossil sources, to produce more “greener” polyurethane foams and therefore, less dependent on petroleum sources, since the polyol component was substituted by products resulting from biomass liquefaction. The partial and fully exchange of the polyols was accomplished, and the results compared with a reference foam. The foams were afterward, chemical, physical, morphological, and mechanically characterized. The complete replacement of polyether polyol and polyol polyester has presented some similar characteristics as that used as a reference, validating that the path chosen for the development of more sustainable materials is on the right track for the contribution to a cleaner world.     

MoS_2/Bi_2S_3异质结光催化剂的制备及其光催化性能

以五水硝酸铋为铋源、钼酸钠为钼源、硫脲为硫源,采用简单的一步水热法合成了MoS_2/Bi_2S_3异质结光催化剂,采用XRD,SEM,TEM,BET,UV-Vis DRS技术对其进行了表征。表征结果显示,MoS_2纳米片在Bi_2S_3微棒表面生长,增加了比表面积和活性位点,并形成异质结构,促进了光生载流子的迁移,抑制了电子-空穴对的再复合。实验结果表明:钼酸钠与五水硝酸铋的质量比为1∶2时制备的复合光催化剂性能最好,反应180min时对亚甲基蓝的去除率可达96.4%,明显高于MoS_2和Bi_2S_3,且具有较高的稳定性;该催化剂对罗丹明B、甲基橙和4-硝基苯酚的去除率分别为97.1%、93.1%和90.5%,表明其对污染物具有普适性。     

流量分布系数对低压热释放速率测量的影响

热释放速率是反映火灾规模的重要参数,但高海拔低压地区可燃物燃烧的热释放速率测量一直未得到有效解决。为此,引入烟气管道流量分布系数,并对其进行低压修正,基于耗氧原理分析了低压条件下可燃物燃烧的热释放速率测量原理,提出了低压燃烧热释放速率的计算方法。在此基础上,设计并搭建了低压燃烧舱模拟高海拔低压环境,开展了不同静态低压条件下的正庚烷池火试验,并对烟气管道流量分布系数与不同的静态环境低压进行线性关系、指数关系等拟合,发现试验工况压力下的流量分布系数与响应的环境压力呈指数函数关系,且拟合度高达97.2%。采用指数函数关系并根据能量守恒对试验测量出的低压热释放速率进行修正,误差不超过5%,表明该方法可行。     

欧盟空气质量监测现状及加强我国空气质量监测体系建设的建议

从欧盟空气质量监测政策和监测网络建设现状两个方面描述了欧盟空气质量监测发展现状。分析了我国空气污染现状和空气质量监测体系中存在的问题,并借鉴欧盟的经验,提出了加大政策支持和财政保障力度、逐步健全空气质量监测网络体系、加强空气质量监测技术研究、完善空气质量监测数据库、开展能力建设、提高公众参与度等加强我国空气质量监测体系建设的建议。     

Study on the denitrification performance of FexLayOz/activated coke for NH3-SCR and the effect of CO escaped from activated coke at mid-high temperature on catalytic activity

Currently, activated coke is widely used in the removal of multiple pollutants from industrial flue gas. In this paper, a series of novel Fe_xLa_yO_z/AC catalysts was prepared by the incipient wetness impregnation for NH₃-SCR denitrification reaction. The introduction of Fe-La bimetal oxides significantly improved the denitrification performance of activated coke at mid-high temperature, and 4% Fe_0.3La_0.7O_1.5/AC exhibited a superior NO_x conversion efficiency of 90.1% at 400 °C. The catalysts were further characterized by BET, SEM, XRD, Raman, EPR, XPS, FTIR, NH₃-TPD, H₂-TPR, et al., whose results showed that the perovskite-type oxide of LaFeO₃ and oxygen vacancies were produced on the catalysts’ surfaces during roasting. Fe-La doping enhanced the amount of acid sites (mainly Lewis and other stronger acid sites) and the content of multifarious oxygen species, which were beneficial for NO_x removal at mid-high temperature. Moreover, it was investigated that the effect of released CO from activated coke at mid-high temperature on the NO_x removal through the lifetime test, in which it was found that a large amount of CO produced by pyrolysis of activated coke could promote the NO_x removal, and long-term escaping of CO on the activated coke carrier did not have a significant negative impact on catalytic performance. The results of the TG-IR test showed that volatile matter is released from the activated coke while TG results showed that the weight loss rate of 4% Fe_0.3La_0.7O_1.5/AC only was 0.0015~0.007%/min at 300–400 °C. Hence, 4% Fe_0.3La_0.7O_1.5/AC had excellent thermal stability and denitrification performance to be continuously used at mid-high temperature. Finally, the mechanisms were proposed on the basis of experiments and characterization results.

     

硅/铝掺杂纤铁矿的表面性质及对F-的吸附性能

纤铁矿是土壤中重要的活性矿物组分,常与硅、铝元素共存,对土壤污染物的迁移有重要的影响。采用氧化水解法制备了不掺杂和硅、铝掺杂的纤铁矿(分别记为Lep、Si-Lep、Al-Lep),通过X-射线衍射(XRD)、扫描电镜(SEM)、N2吸附/脱附、质子电位滴定等方法对样品进行表征和表面性质分析,并研究了3种样品对F~-的吸附性能。结果表明:与Lep相比,Si-Lep、Al-Lep的结晶度降低且铝掺杂显著抑制了纤铁矿向针铁矿转化。Lep、Si-Lep和Al-Lep的BET比表面积分别为25.37、28.18、32.51m2/g,孔体积、平均孔径和表面分形度均依次增大。Lep、Si-Lep和Al-Lep样品的电荷零点(pHPZC)依次为7.10、6.80、6.50;3种样品的表面羟基密度分别为0.33、0.32、0.36mmol/g。Lep、Si-Lep和Al-Lep对F~-的最大吸附量分别为6.58、7.32、9.88mg/g;与Lep相比,Si-Lep和Al-Lep对F~-的准二级动力学速率常数分别降低至0.013、0.014g/(mg·min);Si-Lep对F~-的吸附亲和力增大,而Al-Lep对F~-的吸附亲和力降低。